 |
| In preperation for the inverted fork installation on the virago project we had to disassemble them for rebuild. While they are apart it was a good time to chop some un-needed shit. Since we are going to run no fender, the fender supports had to go. The tubes got wrapped in tape to protect them from scatches and the lowers got clamped to the grinder table. |
 |
| Utilizing a 4" cut off wheel, the fender mounting tabs were removed. |
 |
| A short visit with a DA sander, outfitted with 200 grit paper and the mounts got massaged away. |
 |
| Everything laid out for rebuild. I think we may coat the lower legs prior to reassembly. |
No comments:
Post a Comment